Remove/install rear engine mount - AR22.10-P-1160IW

ENGINE 112 in MODEL 220.087 /187

ENGINE 113 in MODEL 220.083 /084 /183 /184

Fig 1: Identifying Exhaust Shielding Plate And Rear Engine Mount

Fig 2: Identifying Rear Engine Crossmember

Fig 3: Identifying Rear Engine Mount And Engine Mount Carrier

	Remove/Install
	Notes on self-locking nuts and bolts		AH00.00-N-0001-01A
	Lethal injuries are possible if vehicle slips off of lifting platform	Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
1	Raise vehicle.
2	Remove rear engine compartment paneling at the bottom		AR61.20-P-1105M
3	Dismount exhaust shielding plate (1) for front propeller shaft behind transfer case	Remove exhaust shielding plate (1) via right exhaust pipe.
4	Support automatic transmission with assembly lift and transmission platform (01)	Transmission plate	*WE58.40-Z-1018-11A
5	Dismount rear engine mount (2) at rear engine crossmember (3), for this step unscrew bolts (4)		*BA22.10-P-1002-01L
6	Dismount rear engine crossmember (3)		*BA22.10-P-1003-01L
7	Dismount rear engine mount (2) at engine mount carrier (5)	Observe the environmental protection regulations for the disposal of engine mounts Dispose engine mounts into mixed scrap.	*BA22.10-P-1015-01L
8	Install in the reverse order

ENGINE MOUNTS, ENGINE SUPPORTS

Number	Designation		Engine 112.975, 113.948/966 in Model 220
BA22.10-P-1002-01L	Screw of rear engine mount to rear engine crossmember	Nm	40
BA22.10-P-1003-01L	Bolt of rear engine crossmember to body	Nm	40
BA22.10-P-1015-01L	Nut of rear engine mount to engine mount carrier	Nm	40

WORKSHOP EQUIPMENT

WE58.40-Z-1018-11A

Transmission platform