Remove, install oil level sensor - AR18.40-P-5111L

ENGINE 137 in MODEL 215, 220 

ENGINE 275 in MODEL 215, 216, 220, 221, 230 

Fig 1: Identifying Oil Level Sensor Remove/Install Components

Fig 2: Identifying Oil Pan Bolts And Cover

	Remove/install
1	Remove lower engine compartment paneling	Model 215, 220	AR61.20-P-1105M
		Model 230	AR61.20-P-1105R
		Model 216	AR61.20-P-1105SX
		Model 221 without code (Z07) Top protection
		Model 221 with code (Z07) Top protection	AR61.20-P-1105SXS
2	Drain engine oil or extract	Refer to engine oil and filter change
		Model 215.378, 220.178/ 878	AP18.00-P-0101L
		Model 215.376 / 379, 220.176 /179, 230	AP18.00-P-0101H
		Model 216, 221	AP18.00-P-0101SZ
3	Unscrew bolts (8) and remove cover (9).	Model 230
4	Detach plug (6) from oil sensor (oil level, temperature and quality) (B40)
5	Remove oil pan bottom section (1)		AR01.45-P-7555L
6	Remove bolts (4, 5)		*BA18.40-P-1002-01B
7	Pull oil sensor (oil level, temperature and quality) (B40) out of oil pan	Installation:  Replace O-ring (7).
8	Install in the reverse order
	Risk of accident  caused by vehicle starting off by itself when engine is running. Risk of injury  caused by contusions and burns during starting procedure or when working near the engine as it is running	Secure vehicle to prevent it from moving by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts.	AS00.00-Z-0005-01A
9	Check for leaks with engine running

OIL LEVEL/OIL PRESSURE SENSOR