Removing and installing door catch - AR72.10-P-2100M

MODEL 220 

Fig 1: Identifying Door Catch

	Removing, installing
1	Detach/attach door lining	at front door	AR72.10-P-1000M
		at rear door	AR72.12-P-1010M
2	Pull off sound deadening mat in front area of inner door panel
3	Remove screws (1) from A-pillar and B-pillar, respectively	Screw at A-pillar	*BA72.10-P-1004-01E
		Screw at B-pillar	*BA72.12-P-1004-01D
4.1	Remove/install door speaker in front door		AR82.62-P-7845I
5	Remove screws (2) from door	Hold door catch tight from inside for this step Avoid damaging paint
		Screw to inner door panel of front door	*BA72.10-P-1005-01E
		Screw to inner door panel of rear door	*BA72.12-P-1005-01D
6	Remove door retaining strap through installation opening in inner door panel
7	Install in the reverse order

FRONT DOOR TIGHTENING TORQUE

Number	Designation		Model 220
BA72.10-P-1004-01E	Screw for door retaining strap on body	NM	14
BA72.10-P-1005-01E	Bolt for door catch to inner door panel	NM	10

REAR DOOR TIGHTENING TORQUE

Number	Designation		Model 220
BA72.12-P-1004-01D	Screw for door retaining strap on body	NM	14
BA72.12-P-1005-01D	Bolt for door catch to inner door panel	NM	10