Design of burner housing - GF83.70-P-4000-03A

Model 210 with stationary heater 

Model 210 up to 31.08.96 with heater booster 

Model 463 as of 01.06.94 with stationary heater 

In burner housing,

• burner pipe (2),
• burner with burner insert (1),
• glow pin (A6r2)

and

• flame monitor (A6r3)

are combined as one unit.

Coolant supply (4) and coolant outlet (3) are located on burner housing.

Illustration shows burner housing of stationary heater unit with coolant circulating pump (A6m1) connected. On heater booster heater unit without circulating pump, pump installation opening on burner housing is sealed tight with a sealing plug.

With stationary heater unit, version of burner insert depends on fuel.

Differentiating feature: 

• Burner insert for petrol (5) with perforated plate
• Burner insert for diesel (6) with non-woven material

Heater booster heater unit is designed, in principle, for diesel operation.