ME-SFI driving mode, function - GF07.61-P-2005G
ENGINE 273 in MODEL 463.202/222/236/237 up to 31.5.12 as of model year 2009/YoM 08
Function requirements for driving mode for the ME gasoline injection and ignition system (motor electronics) (ME), general points
- Circuit 87M ON (engine control ON)
- Engine running
Driving mode, general points
The following partial functions are active in driving mode and are described in the following documents:
- ME-SFI fuel supply, function
- ME-SFI injection regulation, function
- Motor electronics (ME) ignition system, function
- ME-SFI Start, post-start phase and warm-up enrichment, function
- ME-SFI alternator interface function
- ME-SFI engine speed signal, function
- ME-SFI maximum engine speed limitation, function
- ME-SFI limiting maximum vehicle speed, function
- ME-SFI safety fuel shutoff, function
- Intake manifold switchover function
- ME tumble flap switchover function
- ME-SFI lambda control, function
- ME-SFI two-sensor control, function
- ME-SFI oxygen sensor heater function
- Self-adjustment of mixture formation, function
- Smooth engine running analysis, function
- ME-SFI thermal management, function
- ME-SFI engine torque requests function
- ME-SFI overrun fuel shutoff, function
- Camshaft adjustment, function
- ME-SFI transmission shift delay, function
- ME-SFI knock control function
- Overheating/pinging protection, function
- Air injection, function
- ME-SFI electronic accelerator, function
- Electronic accelerator pedal emergency running mode, function
- Purging function
- System purging with leak test function (with code (ZU8) USA version)
- Monitoring catalytic converter efficiency, function
| ME-SFI fuel supply, function | GF07.61-P-3004G | ||
| ME-SFI injection regulation, function | GF07.61-P-3002G | ||
| Motor electronics (ME) ignition system, function | GF07.61-P-3008G | ||
| ME-SFI Start, post-start phase and warm-up enrichment, function | GF07.61-P-3014G | ||
| ME-SFI alternator interface function | GF07.61-P-3003G | ||
| ME-SFI engine speed signal, function | GF07.61-P-3017G | ||
| ME-SFI maximum engine speed limitation, function | GF07.61-P-3007G | ||
| ME-SFI limiting maximum vehicle speed, function | GF07.61-P-3019G | ||
| ME-SFI safety fuel shutoff, function | GF07.61-P-3018G | ||
| Intake manifold switchover function | GF07.61-P-3028G | ||
| ME-SFI tumble flap switchover function | GF07.61-P-4017G | ||
| ME-SFI lambda control, function | GF07.61-P-4022G | ||
| ME-SFI two-sensor control, function | GF07.61-P-3020G | ||
| ME-SFI oxygen sensor heater function | GF07.61-P-3024G | ||
| Self-adjustment of mixture formation, function | GF07.10-P-1029G | ||
| Smooth engine running analysis, function | GF07.10-P-1030G | ||
| ME-SFI thermal management, function | GF07.61-P-4012G | ||
| ME-SFI engine torque requests function | GF07.61-P-4013G | ||
| ME-SFI overrun fuel shutoff, function | GF07.61-P-4019G | ||
| Camshaft adjustment, function | GF07.61-P-4021G | ||
| ME-SFI transmission shift delay, function | GF07.61-P-4023G | ||
| ME-SFI knock control function | GF07.61-P-4031G | ||
| Overheating/pinging protection, function | GF07.61-P-4027G | ||
| Air injection, function | GF14.30-P-3012G | ||
| ME-SFI electronic accelerator, function | GF30.20-P-3012G | ||
| Electronic accelerator pedal emergency running mode, function | GF30.20-P-4026G | ||
| Purging function | GF47.30-P-3015G | ||
| Purging system with leak test function | For code (ZU8) USA version | GF47.30-P-3016G | |
| Monitoring catalytic converter efficiency, function | GF49.10-P-3033G |