General information on repair notes - GF01.00-P-9611-01G

Engine 113.962 in Model 463

15.03.07

The document has been updated to this date and will no longer be subject to revision.

Shown on engine 113.962

Timing case cover

Seal (silicone)

Timing case cover, oil pan top section, oil pan bottom section and end cover are sealed with a silicone sealant at the points A, C, D, E, F and G.

No sealant should be applied to the timing case cover at the point (B), pressure oil galleries to crankcase, with the exception of around bolt hole G.

Sealing compound which is applied to the points B, is caught by the oil flow and cloggs the oil supply holes of the: main bearing, camshaft bearing, rocker arm and oil spray nozzles.

Fig 1: Identifying Timing Case Cover With Sealant And No Sealant Area

Courtesy of MERCEDES-BENZ USA

Oil pan top section

Repair instruction

The sealing compound must be applied as a 2 mm thick bead. After this, fit together the parts immediately. The silicone bead must not be spread.

It is important to apply the sealing compound as specified (refer to figs.).

Fig 2: Identifying Oil Pan Top Section

Courtesy of MERCEDES-BENZ USA

Oil pan bottom section

Fig 3: Identifying Oil Pan Bottom Section

Courtesy of MERCEDES-BENZ USA

End cover

Fig 4: Identifying End Cover

Courtesy of MERCEDES-BENZ USA