Retrofit iPod - AZ82.60-P-0014T

MODEL 211.0## 1# with CODE (526) COMAND (without navigation) except CODE (924) Bivalent natural gas drive except vehicles with FSE11, except vehicles with FSE12 

MODEL 211.0## 1# with CODE (527) COMAND APS (with navigation) except CODE (924) Bivalent natural gas drive except vehicles with FSE11, except vehicles with FSE12 

MODEL 211.0## 1# with CODE (528) HIGH Class USA except CODE (924) Bivalent natural gas drive except vehicles with FSE11, except vehicles with FSE12 

MODEL 211.0## 1# with CODE (530) COMAND APS USA (with navigation system) except CODE (924) Bivalent natural gas drive except vehicles with FSE11, except vehicles with FSE12 

Shown on model 211 up to model refinement 06/2006 

Fig 1: Identifying iPod (In Glove Compartment), iPod Wiring Harness Connector And iPod Mounting Tray (Shown On Model 211)

	Removal
	Notes on avoiding damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Risk of explosion  caused by oxyhydrogen gas. Risk of poisoning and caustic burns  caused by swallowing battery acid. Risk of injury  caused by burns to skin and eyes from battery acid or when handling damaged lead-acid batteries	No fire, sparks, open flames or smoking. Wear acid-resistant gloves, clothing and glasses. Only pour battery acid into suitable and appropriately marked containers.	AS54.10-Z-0001-01A
1	Disconnect battery ground line
			AR54.10-P-0003T
	Notes on battery	All models	AH54.10-P-0001-01A
2	Remove side trim in trunk	On left and right.
		Vehicles without  through-loading feature, code 287	AR68.30-P-4800T
		Vehicles with  through-loading feature, code 287	AR68.30-P-4800TA
3	Remove SAM signal acquisition and actuation module control unit with fuse and relay module from the luggage compartment	Do not disconnect electrical connectors.
			AR54.21-P-1258T
4	Remove right rear seat cushion
		Vehicles without  through-loading feature, code 287	AR91.12-P-1020T
		Vehicles with through-loading feature, code 287	AR91.12-P-1020TA
5	Remove side upholstery from right rear seat backrest
6	Remove paneling on B-pillar	Undo in lower area to the right far enough until the cable duct is accessible.
			AR68.30-P-4700T
7	Remove front floor covering (right)
			AR68.20-P-2070T
8	Remove COMAND operating, display and controller unit
		With COMAND (without navigation system), code 526, with COMAND APS (with navigation system), code 527.	AR82.85-P-1000T
	Install
9	Retrofit iPod interface wiring harness		AZ82.60-P-0001-01T
10	Retrofit iPod wiring harness	In both variants the glove compartment remains installed.
		With air conditioning (or Tempmatic for USA), code 580. As of 09.2004 with comfort automatic air conditioning, code 581.	AZ82.60-P-0001-02T
		Up to 08.2004 with comfort automatic air conditioning, code 581.	AZ82.60-P-0001-02TTT
11	Retrofit iPod interface		AZ82.60-P-0001-03T
12	Glue in iPod cradle (29) in glove box using MB universal glue	Can be stuck to clipboard or base of glove compartment.
		MB universal glue	*BR00.45-Z-1003-02A
13	Connect iPod (1) to iPod wiring harness plug (23) in glove compartment
14	Place iPod (1) into the iPod cradle (29)
15	Install remaining parts onto vehicle	Operation steps 8 to 1.
16	Perform retrofit variant coding	Only perform if telephone not installed.
			AN82.61-P-0001-05T
		STAR DIAGNOSIS diagnosis system	*WH58.30-Z-1048-13A