Remove/install Parktronic system (PTS) sensors in rear bumper - AR54.65-P-0002T
MODEL 211.0 with CODE (220) Parktronic system (PTS)
Shown on vehicle up to 31.5.06, right outer sensor, rear bumper
Shown on vehicle as of 1.6.06
Fig 2: Identifying (PTS) Sensors Components - Right Outer Sensor, Rear Bumper - Shown On Vehicle As Of 1.6.06
MODIFICATION NOTES
| 8.1.04 | Disconnect/connect ground line on battery |
| Remove/install | |||
|---|---|---|---|
| 1.1 | Remove ram strip (1) from rear bumper (2) | On vehicles up to 31.5.06 | AR88.80-P-2220TA |
| 1.2 | Remove rear bumper (2) | In vehicles as of 1.6.06 | AR88.20-P-2200T |
| 2.1 | Disconnect electrical connector (5) at the corresponding sensor (A43b7, A43b8, A43b9 or A43b10) | In vehicles as of 1.6.06 | |
| 3.1 | Unlock the locks (3) with the release tool in the direction of the arrow and remove sensor (A43b7, A43b8, A43b9,, or A43b10) from the protective strip (1) | On vehicles up to 31.5.06 | |
| Figure | |||
| 3.2 | Unclip sensor (A43b7, A43b8, A43b9 or A43b10) by hand from the rear bumper (2) and remove | In vehicles as of 1.6.06 | |
| 4 | Install in the reverse order |