Separate inner part of rear center section - AR64.20-P-1000-11TA

Fig 1: Identifying Spot Weld Cutter (201 589 00 51 00)

COMMERCIALLY AVAILABLE TOOLS

Number	Designation
WH58.30-Z-1002-01A	Ball cutter, dia. 12 mm
WH58.30-Z-1006-01A	Vario Drill WS 91 spot weld removing tool
WH58.30-Z-1001-03A	Round wire brush, braided, dia. 70 mm
WH58.30-Z-1024-04A	Abrasive disk, dia. 115 mm, 80 m/s (max. 13,250 rpm)
WH58.30-Z-1001-40A	Tarp (fire-resistant)

WORKSHOP EQUIPMENT

WE58.40-Z-1001-03A	Drill (electric/pneumatic)
WE58.40-Z-1002-03A	Straight grinder (electric/pneumatic)
WE58.40-Z-1003-03A	Angle grinder (electric/pneumatic)
WE58.40-Z-1005-03A	Wet/dry vacuum cleaner

REPAIR MATERIALS

Number	Designation	Order number
BR00.45-Z-1001-07A	Zinc dust paint suitable for spot welding	A 000 986 34 42

Fig 2: Identifying Welding And Cutting Area - Inner Part Of Rear Center Section

1. Expose spot welds and cut out with spot weld cutter (areas A and B).
2. Expose spot welds and cut out with spot weld cutter (area C and Y).
3. Remove inner bottom rear center section
   Fig 3: Identifying Welding And Cutting Area - Inner Part Of Rear Center Section

   
   Fig 4: Identifying Grinding Flanges Area

   
4. Grind connection flanges down to bare metal in shaded areas. Sand spot weld flanges to bare metal on both sides
5. Coat insides of spot weld flanges with zinc dust paint.