Install longitudinal member end element and weld in - AR64.20-P-1200-05T
COMMERCIALLY AVAILABLE TOOLS
| Number | Designation |
|---|---|
| WH58.30-Z-1003-01A | Electrode miller |
| WH58.30-Z-1003-02A | Clamping pliers |
| WH58.30-Z-1038-02A | Manual temporary fastener, dia.6.4 mm - clamping range 0 -15 mm, identification color silver Firma Hausmann GmbH D-34346 Hann. Munden, Germany |
| WH58.30-Z-1003-29A | Hand riveter |
WORKSHOP EQUIPMENT
| WE58.40-Z-1001-02A | Inert gas welder |
| WE58.40-Z-1002-02A | Spot welder |
| WE58.40-Z-1003-14A | Blind rivet tool |
REPAIR MATERIALS
| Number | Designation | Order number |
|---|---|---|
| BR00.45-Z-1003-01A | Sealant | A 001 989 63 20 |
| BR00.45-Z-1003-05A | Preservation agent | A 000 986 72 70 05 |
| BR00.45-Z-1001-07A | Zinc dust paint suitable for spot welding | A 000 986 34 42 |
- Install end section, fit and fasten with clamping pliers.
- Drill pilot hole (area AE).
- Drill dia. 6.5 mm rivet holes (area X).
- Remove locking lug.
- Deburr rivet holes on both sides
Shown on model 211.0
- Install end section, fit and fasten with screw-on clamping gripper.
- Weld in end section with
(areas AB, E, N, O and V).
- Weld in end section on longitudinal member with
areas (AE and W).
- Rivet end section with 6.4 x 14 mm dia. Polygrip flat head rivet (area X).
Shown on model 211.0