LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2006 >> E320 >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Electrical System, Equipment & Instructions - Retrofitting & Conversion - 211 Chassis - 1 Of 2 >> Retrofitting & Conversion >> Retrofit ultrasonic back-up assist - AZ54.65-P-0001 >> Retrofit ultrasonic back-up assist - AZ54.65-P-0001TT >> Installing display instrument - AZ54.65-P-0001-05TT

Installing display instrument - AZ54.65-P-0001-05TT

  1. Place backing plate (20) in the center of the prestamped recess at the rear of the headliner from above, mark the internal dimensions and cut out carefully.
    Fig 1: Identifying Backing Plate Dimensions
    G04984484
  2. Place backing plate (20) on the cutout from above. Clip bracket (21) into backing plate (20) from below.
    Fig 2: Identifying Bracket Into Backing Plate
    G04984485
  3. Push rear PTS warning display (A44/3) into bracket (21) from below with the connecting coupling pointing to the left, and lock by pushing towards the left side.
    Fig 3: Pushing Rear Warning Element Into Bracket
    G04984486
  4. Connect warning element wiring harness (22) and attach to headliner with adhesive felt tape as shown in the diagram.

    Shown on sedan 

    Fig 4: Identifying Headliner With Adhesive Felt Tape
    G04984487
  5. Route warning element wiring harness (22) along existing cables on left side of headliner and fasten.

    IMPORTANT After installing the headliner, the cables should be routed to the left C-pillar along existing cables.

    Fig 5: Identifying Warning Element Wiring Harness
    G04984488
  6. Route warning element wiring harness (22) with overhead control panel and frame floor system connector (X25/8) to the side wall beside the left rear door.
    Fig 6: Identifying Parking Assist Wiring Harness
    G04984489
scientia non olet · About LEMON Manuals