Remove/install rear brake control cable - AR42.20-P-0525TX

MODEL 219 

Fig 1: Identifying Rear Brake Control Cable Remove/Install Components (1 Of 2)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Rear Brake Control Cable Remove/Install Components (2 Of 2)

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove parking brake shoes		AR42.20-P-0530TX
2	Remove crossmember (35)		*BA62.30-P-1001-01C
3	Support exhaust system using	transmission platform and transmission jack, detach it from rubber retainers and lower	*WE58.40-Z-1018-11A
			*WE58.40-Z-1030-11A
4	Loosen, separate and move heat shields or remove them	Depending on accessibility
		Model 219 except 219.322	AR49.00-P-1000-01TX
		Model 219.322	AR49.10-P-6906TQ
5	Detach retracting spring (94) from bridge (70)	After installing retracting spring (94): ↓
		Relieve load on automatic slack adjuster.	AR42.20-P-0520-02TX
6	Detach front brake cable (85) from automatic cable slack adjuster (92)
7	Preload automatic slack adjuster (92)		AR42.20-P-0520-01TX
8	Detach rear brake cable (86) at automatic cable slack adjuster (92)
9	Unclip rear brake cable (86) from bridge (70)		Figure
10	Pull rear brake cable (86) out of center assembly mount (51)	While working on the rear axle care must be taken to ensure that the surface of all aluminum components do not get any scratches, cracks and notches. Otherwise the service life of the of the parts will be reduced. Lever rubber grommet (86a) out of center assembly mount (51).
11	Pull rear brake cable (86) out of wheel carrier
12	Press together retaining collar (86b) and pull down and out of bracket (86c) together with rear brake cable (86).
13	Install in the reverse order

CROSSMEMBER AND FRONT REINFORCEMENT

Number	Designation		Model 219
BA62.30-P-1001-01C	Bolt, crossmember to body	Nm	25

Fig 3: Identifying Snap-Release Tool (129 589 11 63 00)

Courtesy of MERCEDES-BENZ USA

WORKSHOP EQUIPMENT

WE58.40-Z-1018-11A	Transmission platform
WE58.40-Z-1030-11A	Transmission jack