Remove/install wind deflector - AR77.20-P-2500TX

MODEL 219.3 with CODE (414) Glass electric tilting/sliding roof 

Fig 1: Identifying Wind Deflector Remove/Install Components

Courtesy of MERCEDES-BENZ USA

	Remove/Install
	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	When moving components, ensure that no body parts or limbs are within the operating range of moving parts.	AS00.00-Z-0011-01A
1	Open tilting/sliding roof
2	Unclip sealing rail (2) with suitable screwdriver
3	Lightly press wind deflector (1) downward to one side until height stop (4) is exposed
4	Press wind deflector (1) off toward center of vehicle on one side with mounting wedge (6)	Carefully press off wind deflector (1) Otherwise safety hook (5) can break off
			Figure
5	Slightly lift wind deflector (1) upward, unhook on opposite side and remove	Check whether left and right spring bracket (3) is seated correctly
6	Install in the reverse order
7	Perform teach-in run for tilting/sliding roof obstruction sensor
	Connect STAR DIAGNOSIS and read out fault memory		AD00.00-P-2000-04A
		Diagnosis system STAR DIAGNOSIS	*WH58.30-Z-1048-13A

Fig 2: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA