Remove/install cigarette lighter - AR54.10-P-0030TX

WARNING: This page is about a different car, the 2009 Mercedes-Benz CLK350 and 2008 Mercedes-Benz CLK350. However, it is still accessible from the selected car via links, so may be relevant.

MODEL 209

Shown on model 219

Fig 1: Identifying Cigarette Lighter Components

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Switch off the ignition and remove the transmitter key from the EIS control unit	On vehicles with code (889) Keyless Go, keep pressing the KEYLESS-GO start/stop button until the ignition is switched off. Remove the Keyless Go chipcard or transmitter key from vehicle and store beyond reach of the transmitter (at least 2 m).
2.1	Open ashtray
3	Pull insert (1) out of the housing (3) of the cigarette lighter with front ashtray illumination (R3)
4	Insert pliers (2) into the housing (3) and pull the housing (3) out of the clamping sleeve (4)	The spigots of the pliers (2) must engage in the cutouts of the housing (3) (arrows A).	Figure
5	Disconnect electrical connector of cigarette lighter with front ashtray illumination (R3x1)
6	Unclip clamping sleeve (4) from the ashtray housing by pressing back the catch hooks (arrows B) (5) and remove	Installation: Pay attention to the correct installation position of the clamping sleeve (4).
7	Install in the reverse order

Fig 2: Identifying Pliers (169 589 00 37 00)

Courtesy of MERCEDES-BENZ USA