Starting up taxi functions - AN82.25-P-1000-05M

Model 220

Fig 1: Identifying Taxi Components

The taxi functions are explained in the operating instructions for taxis and taximeters.

Proper knowledge of the taxi functions are a prerequisite for proper programming of the taxi functions.

When taxi equipment is retrofitted in the W220 it is necessary to activate the individual taxi functions with STAR diagnosis.

For this purpose perform the following steps in the diagnosis modules.

	Start-up step	Entry into system	Feedback on display
1	Activating special vehicle multifunction control module (SVMCM)	Select control module	Control modules
2		Select body	Body
3		EIS electronic ignition switch	Connection is completed
4		Adapt control modules	Read coding and change as required
5		Read coding versions and change as required	Control modules
6		Special vehicle multifunction control module (SVMCM)	SVMCM present: yes Version coding for SVMCM
7		Set coding to taxi	Transfer coding
8		Return to SVMCM selection display and activate SVMCM	SVMCM multifunction control module present
9		Set coding to SVMCM	Transfer coding
10		Return to body	-
11		Select SVMCM	Special vehicle multifunction control module (SVMCM)
12		-	Complete connection to SVMCM
13		Adapt control modules	Set control module to basic setting
14		Set control module to basic setting	Control modules. Basic setting performed
15		Perform settings depending on taxi functions installed	Taxi = yes Emergency alarm = yes Emergency call = depending on version
16		Transfer settings	Transfer coding yes
17	Customer specific vehicle adaptation	Read coding and change if required	Only if basic functions are to be changed for specific customer.
		With these functions the roof sign, the two-way radio, the type of alarm and the emergency call can be activated specifically as required by the customer.	Transfer coding to control module yes