Retrofitting washer fluid reservoir and washer fluid hose - AN82.15-P-0001-03M

Model 220 

1. Remove existing grommet from washer fluid reservoir (see arrow) and install headlamp washer fluid pump (M5/2) with grommet.
2. Connect existing connector (6) from engine wiring harness to headlamp washer fluid pump (M5/2).
3. Install washer fluid reservoir and coolant expansion reservoir.
   Fig 1: Removing Existing Grommet From Washer Fluid Reservoir

   
   Fig 2: Identifying Angular Connector, T-Fitting And Washer Fluid Hose

   
4. Attach angular connector (5b) to washer fluid hose (5).
5. Attach washer fluid hose to left telescoping nozzle (4) with connector (5b) and route below cross member on right side of vehicle and fasten with cable straps (see magnified section in figure at left).

   Actuate catch for locking/unlocking connector (5b) (see arrow in figure at bottom left).

6. Install T-fitting (5a) and route washer fluid hose section to right telescoping unit (4), insert connector (5b) into washer fluid hose (5) and connect to telescoping unit (see center figure).

   Actuate catch for locking/unlocking connector (5b) (see arrow in figure at bottom left).

7. Route washer fluid hose section (5) from T-fitting (5a) to headlamp washer fluid pump (M5/2), insert straight connection (5c) into washer fluid hose and connect to washer pump (see figures at right).

   Actuate catch for locking/unlocking connector (5c) (see arrow in figure at bottom right).