Retrofit xenon headlamps - AN82.10-P-0001M
MODEL 220.### 1#
Fig 1: Identifying Headlamp Cleaning System Covering, Left Lamp Unit And Right Lamp Unit Control Unit
| Removal | |||
| Risk of death
caused by high voltage levels present at xenon headlamps. Risk of explosion/risk of fire due to highly flammable materials in the area of damaged xenon bulbs Risk of injury from UV light, hot components at xenon headlamps and glass splinters when xenon bulbs crack Risk of poisoning from inhaling mercury vapors and from swallowing/skin contact with poisonous salts and mercury compounds |
Do not come into contact with parts that are under high voltage. Persons with active electronic implants (e.g. heart pacemakers) must never work on xenon headlamps. Switch off entire lighting system. Wear insulating safety shoes, safety glasses and protective gloves. Remove highly inflammable materials from the hazard area. Ensure the work area is adequately ventilated. | AS82.10-Z-0001-01A | |
| Retrofit xenon headlamps | Model 129, 140, 202, 220 | AH82.10-P-1003-01A | |
| 1 | Disconnect ground line at battery | ||
| AR54.10-P-0003I | |||
| 2 | Remove right front fuse and relay module (K40/7) from right fuse and relay box (F1/1) | ||
| 3 | Remove front bumper | AR88.20-P-2000M | |
| 4 | Remove lamp units | ||
| AR82.10-P-4730M | |||
| 5 | Remove bottom A-pillar trim on right | ||
| 6 | Turn back floor covering on right until footrest is exposed | ||
| 7 | Remove right footrest | ||
| 8 | Remove cover below right instrument panel | ||
| AR68.10-P-1520M | |||
| 8 | Remove cover below left of instrument panel | ||
| AR68.10-P-1500M | |||
| 10 | Remote data link connector (X11/4) | ||
| 11 | Remove left front entry trim | ||
| 12 | Remove left front floor covering | ||
| AR68.20-P-2050M | |||
| 13 | Open left front cable duct | ||
| Install | |||
| 14 | Install xenon light units | ||
| AR82.10-P-4730MA | |||
| 15 | Retrofit headlamp range adjustment wiring harness | AN54.18-P-0003-01M | |
| 16 | Install headlamp range adjustment control unit | ||
| AR82.10-P-4081M | |||
| 17 | Retrofit headlamp cleaning system | AN82.15-P-0001M | |
| 18 | Install remaining parts onto vehicle | ||
| 19 | Affixing warning stickers | AN82.10-P-0002-02A | |
| Check | |||
| 20 | Enter variant coding | ||
| 21 | Set zero position of xenon headlamps | ||
| 22 | Check and correct headlamp adjustment | ||
| AP82.10-P-8260M |
PARTS ORDERING NOTES
| Part no. | Designation | Quantity |
|---|---|---|
| KG 54 | Headlamp range adjustment wiring harness | 1 |
| KG 82 | Retrofit xenon headlamps, right-hand traffic | 2 |
| KG 82 | Headlamp range adjustment control unit | 1 |