Retrofit fiber optical cable wiring harness - AN82.70-P-0002-01MAB
Subscriber sequence after installation (must be complied with):
- COMAND operating, display and control unit (A40/3)
- CD player with changer (in the trunk) (A2/6)
- COMAND operating, display and control unit (A40/3)
- Put D2B fiber optical cable wiring harness (1) according to picture inside the vehicle.
Color markings on the D2B fiber optical cable wiring harness (1) must correspond to the available color markings on existing standard wiring harnesses.
- Guide the slanted D2B coupling (11) with D2B fiber optical cable wiring harness (1) in cable duct, middle left to the mounting position - COMAND.
- Guide D2B fiber optical cable wiring harness (1) with straight D2B coupling (12) in cable duct, left and along existing standard wiring harnesses, through the cable ducts in seat cushion and the rear wall into the trunk compartment.
Do not buckle or extend D2B fiber optical cable, routing radii must be greater than 25 mm!
- Route D2B fiber optical cable wiring harness (1) with straight D2B coupling (12) from the cable duct on rear wall along existing standard wiring harnesses to the left wheelhouse recess inside the trunk compartment.
- Fasten D2B fiber optical cable wiring harness (1) with felt masking tape on the standard wiring harnesses.