Correcting oil level in air conditioning after replacing parts - AR83.30-P-5252E

MODEL 163 with CODE (580) Air conditioning or Tempmatic for USA 

A/C compressor 7SB16 

MODEL 202 with CODE (580) Air conditioning or Tempmatic for USA with CODE (581a) Air conditioning (Automatic) A/C compressor ND6CA17, A/C compressor 7SB16 

MODEL 208 with CODE (580) Air conditioning or Tempmatic for USA with CODE (581a) Air conditioning (Automatic) A/C compressor 7SB16 

MODEL 210 with CODE (580) Air conditioning or Tempmatic for USA with CODE (581a) Air conditioning (Automatic) A/C compressor 7SB16 

MODELS 215, 220 A/C compressor 7SE16 

	Correct oil level
	Carry out work quickly, compressor oil is hygroscopic When evacuating refrigerant, the quantity of compressor oil evacuated must be added again to refrigerant circuit when refilling air conditioning (new oil)
1	Replace A/C compressor, additionally fill with new compressor oil		*BF83.55-P-1008-01A
2	Replace condenser and additionally fill with new compressor oil		*BF83.55-P-1003-01A
3	Replace evaporator and additionally fill with compressor oil		*BF83.55-P-1004-01A
4	Replace fluid reservoir and additionally fill with compressor oil		*BF83.55-P-1005-01A
5	Replace suction pipe from evaporator to A/C compressor and additionally fill with new compressor oil		*BF83.55-P-1006-01A
6	Replace pressure pipe from A/C compressor to condenser and additionally fill with new compressor oil		*BF83.55-P-1007-01A
7	Additional oil quantity when replacing evaporator, rear air conditioning	Model 220	*BF83.55-P-1010-01A
8	Additional oil quantity when replacing rear air conditioning lines	Model 220	*BF83.55-P-1011-01A
9	Switch on air conditioning and allow engine to run at idle speed for approx. 4 minutes	Turn temperature thumb wheel of center nozzles to stop in blue range, or on automatic air conditioning to "Lo" Blower at max.
10	Check function of air conditioning	Air output temperature at center nozzle must not fall below + 50 C, if necessary ↓ Carry out diagnosis