Remove, install rear door damper - AR72.12-P-2200MC

MODELS 220.175 /178 with CODE (Z04) Light armoring 

Fig 1: Identifying Rear Door Damper Remove/Install Components

	Removing, installing
1	Remove door liner from rear door		AR72.12-P-1010MC
2	Remove speaker (1)
3	Remove retainer (4) and remove bolt (3) with washer (5)	At the A-pillar and the door armor plate
4	Remove door damper	Installation:  The noticeable unevenness on the damper housing (arrow) must point upward. Check gasket on door panel, replace if necessary.
5	Install in the reverse order