Installing model designation on trunk lid - AR88.50-P-5050M
MODEL 220
| Installation of model designation | |||
| 1 | Clean trunk lid in area of model designation and heat up to approx. 40 °C with heat radiator | ||
| 2 | Position model designation mount (3) in die (2) for template (4) | ||
| 3 | Position model designation (1) in mount (3) on template (4) | Fig 2 | |
| 4 | Position template (4) on trunk lid (arrows) and hold in place | ||
| 5 | Press model designation (1) onto trunk lid by pressing down die (2) | ||
| 6 | Remove template (4) |