Terminating/ending call, function - GF82.70-P-2001M

MODELS 215.3, 220.0 /1 as of 1.9.03 with CODE (813) Voice control system (VCS) 

Shown on model 211 

Fig 1: Identifying Terminating/Ending Call Function - Shown On Model 211

Function cancellation 

If during a telephone call, the VCS switch (S93/2) is moved away from the driver, then the voice recognition of the voice control system is deactivated and an existing connection broken. The voice recognition is located in the voice control system control unit (A35/11). This is possible at any point during the call. If the device is in input mode, then the user can command the voice recognizer to deactivate the system via the hands-free system microphone group (A67b1) using the voice commands "Cancel" or "Canceling". This is possible at any point during the input mode. Furthermore, the system can be deactivated via closing commands and execution commands, in other words, the system is deactivated after entering a phone number, for instance at the end of the execution command "Dial", or after creating a phone book with the execution commands "Accept" or "Memory". Moreover, the system demands the confirmation command "Yes" when a station or a telephone number is deleted. If this command is not issued, the systems aborts the deletion process.

Ending call 

The call is ended via the accept/terminate phone call button (S111s3) in the multifunction steering wheel or via the VCS switch (S93/2). If the user fails to press the button or switch (calling party has put phone down) at the end of the call, then the call is deemed to be still active by the VCS. An incoming call can thus not be recognized by the VCS, which in turn means that the connection cannot be established.