Pulling off joint flange; Radial seal ring and joint flange on drive pinion modified - AR35.31-P-0550-06B

Rear axle center assembly with 185 mm, 210 mm dia. ring 01.04.98 

Fig 1: Identifying Puller (129 589 01 33 00)

1. 1. If necessary, mark joint flange relative to drive pinion.
2. Pull joint flange off drive pinion, use puller (062) if necessary.

   Shown: 168 mm dia. rear axle center assembly 

   Fig 2: Pulling Joint Flange Off Drive Pinion - Shown: 168 Mm Dia. Rear Axle Center Assembly