Connect STAR DIAGNOSIS and read out fault memory - AD00.00-P-2000-04A

Illustrated on model 210

Fig 1: Identifying STAR DIAGNOSIS And Data Link Connector - Illustrated On Model 210

Illustrated on model 163

Fig 2: Identifying STAR DIAGNOSIS And Data Link Connector - Illustrated On Model 163

Shown on model 164.1

Fig 3: Identifying STAR DIAGNOSIS And Data Link Connector - Shown On Model 164.1

Shown on model 461.302

Fig 4: Identifying STAR DIAGNOSIS And Data Link Connector - Shown On Model 461.302

Illustrated on model 171.4

Fig 5: Identifying STAR DIAGNOSIS And Data Link Connector - Illustrated On Model 171.4

Connect STAR DIAGNOSIS (0100) to diagnostic socket, on the data link connector (X11/4) or on the data link connector (1.3) (X11/22).
Switch on ignition.
Start the Diagnosis Assistance System.
In the "Model" menu, select the sub menu "Other model series".
Go through the instructions on the screen:
- Enter the control unit version.
- Read fault memory, erase.
- Read actual values.
- Perform actuations.
- Adaptation of control units
Disconnect STAR DIAGNOSIS (0100).

Stored faults which may be caused by disconnecting cables or by simulation during testing operations must be deleted in the diagnostic trouble code memory following completion of the operations.