Install display instrument - AZ54.65-P-0001-05MC

Model 203.7 

1. Connect connector for rear interior lamp (E15/3) to rear PTS warning indicator (A44/3) (see arrow).
2. Connect warning indicator wiring harness (1b) to 3-pin connector for rear PTS warning indicator (A44/3) and route to left C-pillar along headliner.
   Fig 1: Locating PTS Warning Indicator

   
3. Open 3-pin connector for plug connection (X35/37) on opposite side of warning indicator wiring harness (1b) and remove green/white, brown/yellow and black/pink (gn/ws, br/ge, sw/rs) leads.

   3-pin connector is eliminated.

   Fig 2: Identifying Warning Indicator Wiring Harness And 3-Pin Connector For Plug Connection

   
4. Insert green/white, brown/yellow and black/pink (gn/ws, br/ge, sw/rs) leads for warning indicator wiring harness (1b) into chambers (4, 5 and 6) of additionally ordered 6-pin connector for the warning indicator connector (X35/37).

   Insert leads to match the colors of the leads in chambers 4, 5 and 6 of white 6-pin warning indicator connector (X35/37) for ultrasonic back-up assist wiring harness (1).

   Fig 3: Identifying Warning Indicator Connector, Wiring Harness And Chambers