Removing standard wheels - AZ40.10-P-0001-03B
- 1.1 Remove hubcaps from steel disk wheels.
- 2 Slacken wheel bolts.
- 3 Raise vehicle.
- 4 Unscrew wheel bolts.
When unscrewing the last wheel bolt, make sure that the wheel does not tip off the hub out of control.
- 5 Remove wheel.
If steel disk wheels were previously installed 5 of the removed standard wheel bolts must be kept with the spare wheel. The standard spare wheel can be used as an emergency wheel.
Because handling is altered by the different tire tread circumferences and wheel offsets, a maximum speed of no more than 80 km/h is permissible.