Remove/install torsion bar on rear axle - AR32.20-P-0315P

MODELS 203, 209.3 /4 

Fig 1: Identifying Torsion Bar On Rear Axle Remove/Install Components

	Remove/Install
	Risk of death.  Death may result if vehicle slips or topples from the lifting platform.	Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
	Replace self-locking nuts and bolts.		AH00.00-N-0001-01A
1	Detach torsion bar (77) from left and right link rod (78)	Nut, link rod (78) to torsion bar	*BA32.20-P-1001-04C
2	Unscrew retaining bracket from torsion bar bracket on rear axle carrier (77d)	Bolt, retaining bracket to torsion bar bracket	*BA32.20-P-1006-04C
3	Take off torsion bar (77)	Pull off rubber mount (2c), check and replace if necessary. Do not use grease or lubricants.
4	Detach link rod (78)		AR32.30-P-0630-01P
		Bolt, connecting rod to wheel carrier	*BA32.20-P-1005-04C
5	Install in the reverse order

REAR AXLE TORSION STRUT

Number	Designation		Model 203	Model 209
BA32.20-P-1001-04C	Nut, connecting rod to torsion strut	NM	40	40
BA32.20-P-1005-04C	Bolt, connecting rod to wheel carrier	NM	40	40
BA32.20-P-1006-04C	Bolt, bracket to torsion bar bracket.	NM	30	30