Remove/install track rod and replacement of rubber mount - AR35.20-P-0112P

MODEL 203, 209 

Fig 1: Identifying Tie Rod And Rubber Mount Remove/Install Components - Shown On Model 203, 209

	Remove/install
	Risk of death  caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
Installation	Replace self-locking nuts and bolts		AH00.00-N-0001-01A
1	Raise vehicle with lifting platform		AR00.60-P-1000P
2	Remove link rod (6k)		*BA32.20-P-1001-04C
			*BA32.20-P-1005-04C
3	Remove tie rod from wheel carrier	Do not damage rubber sleeve when removing.
			*BA35.20-P-1002-04A
			Fig 2
			Fig 3
4	Mark installation position of eccentric disk relative to the rear axle carrier (arrow)
5	Remove bolt (4a) and remove tie rod (4)		*BA35.20-P-1001-04A
	Checking
6	Check rubber mount (4b) for damage, replace rubber mount (4b) if necessary		AR35.20-P-0112-01P
7	Install in the reverse order
8	Perform chassis alignment		AR40.20-P-0200P

TIE ROD

Number	Designation			Model 203	Model 209
BA35.20-P-1001-04A	Self-locking nut, track rod to rear axle carrier	Stage 1	Nm	70	50
		Stage 2	∠ °	-	45
BA35.20-P-1002-04A	Self-locking nut, tie rod to wheel carrier	yellow M10x1	Nm	-	-
		silver or blue M10x1	Nm	-	-
		silver or blue M10x1.5	Nm	30	30

REAR AXLE STABILIZER BAR

Number	Designation		Model 203	Model 209
BA32.20-P-1001-04C	Nut for attaching link rod to torsion bar	Nm	40	40
BA32.20-P-1005-04C	Bolt, link rod to wheel carrier	Nm	40	50

Fig 2: Identifying Thrust Washer M 10X1.5 (210 589 04 63 00)

Fig 3: Identifying Puller (201 589 01 33 00)