Remove/install spring link rubber mount Harder spring link rubber mount Spring link rubber bearings standardized - AR35.20-P-0114-01B

Model 129 

Models 129, 202 

Fig 1: Identifying Removal And Installation Tool (129 589 01 43 00)

Remove 

1. Press rubber mount (6b) out of spring link using the removal and installation tool (06a, 06b).

   In order to be able to press out jammed rubber mounts (6b) precisely, first press small protrusion of rubber mount up to spring link sleeve using a flat thrust washer (06x).

   Fig 2: Identifying Rubber Mount And Removal/Installation Tool

   
   Fig 3: Identifying Rubber Mounts And Flat Thrust Washer

   

   Install 

2. Press rubber mount (6b) into spring link using removal and installation tool (06a, 06b) until both ends of the steel sleeve are the same distance from the spring link sleeve.
   Fig 4: Identifying Rubber Mount And Removal/Installation Tool