Remove/install camber strut - AR35.20-P-0110P

MODELS 203, 209.3 /4 

Fig 1: Identifying Camber Strut Remove/Install Components - Shown On Models 203, 209.3 /4

	Remove/Install
	Risk of death  due to the vehicle slipping off or toppling off the lifting platform	Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
1	Remove wheel.	See ↓
		Remove/install wheels, rotate if necessary.	AP40.10-P-4050Z
Installation	Replace self-locking nuts and bolts
	When tightening nuts and bolts, move rear axle shafts to approximately horizontal position
2	Unscrew bolt of tension arm (3) at wheel carrier		*BA35.20-P-1002-03A
3	Unscrew bolt of camber strut (2a) at rear axle carrier	Press down camber strut (2).
		Self-locking nut, camber strut to rear axle carrier.	*BA35.20-P-1001-02A
		Box wrench	Fig 3
4	Unscrew camber strut (2) at wheel carrier	Self-locking nut, camber strut to wheel carrier.	*BA35.20-P-1002-02A
		Retainer wrench	Fig 2
5	Install in the reverse order

CAMBER STRUT

Number	Designation			Model 203	Model 209
BA35.20-P-1001-02A	Self-locking nut, camber strut to rear axle carrier.	1st stage	Nm	70	50
		2nd stage	∠ °	-	45
BA35.20-P-1002-02A	Self-locking nut, camber strut to wheel carrier.	M10	Nm	-	-
		M12	Nm	70	70

TENSION ARM

Number	Designation			Model 203	Model 209
BA35.20-P-1002-03A	Self-locking nut, tension arm to wheel carrier	1st stage	Nm	70	50
		2nd stage	∠ °	-	45

Fig 2: Identifying Retaining Wrench (202 589 00 10 00)

Fig 3: Identifying Ring Wrench (129 589 01 03 00)