Pressing off, pressing in radial seal at side of rear axle housing - AR35.31-P-0540-05FF

Fig 1: Identifying Drift (126 589 00 15 00)

Fig 2: Identifying Drift (211 589 00 15 00)

Pressing off 

1. Press radial seal (32) out of housing using a suitable screwdriver.
   Fig 3: Pressing Radial Seal Out Of Rear Axle Housing Using A Suitable Screwdriver

   

Pressing in 

2. Coat sealing lip of new radial seal (32) with universal hypoid gear oil.
3. Press in radial seal (32a) using a drift (049b).
   Fig 4: Pressing In Radial Seal Using Drift