Drilling holes on rear shelf - AZ68.30-P-0002-01P

Model 203.0 up to chassis no. A054321 and F036591 

Hole pattern, rear shelf toward right front of vehicle 

Fig 1: Hole Pattern, Rear Shelf Toward Right Front Of Vehicle

1. Drill four holes on left and right sides of rear shelf as shown in the two illustrations.

   The reference point for hole pattern on the right side of the rear shelf when facing toward right front of vehicle is the standard hole in the rear shelf marked with an arrow.

   Hole pattern, rear shelf toward left front of vehicle 

   Fig 2: Hole Pattern, Rear Shelf Toward Left Front Of Vehicle

   
2. Drill pilot holes and drill out with Q 7.5 mm dia. bit.
3. Deburr drill holes and apply primer.