Removing and installing tilting rear seat - AR91.12-P-1720PA

MODEL 203.2 /7 

Shown in model 203.2 

Fig 1: Identifying Seat Adapter Screw Clips And Seat Adapter - Shown In Model 203.2

Shown in model 203.2 

Fig 2: Identifying Tilting Rear Seat Remove/Install Components - Shown In Model 203.2

Shown in model 203.2 

Fig 3: Identifying Front/Rear Loading Floor, Front Cargo Retainer, Rear Backrest And Nuts - Shown In Model 203.2

	Removing, installing
1	Remove rear headrests		AR91.16-P-1770P
2	Release rear seat cushions (1, 2) and tip forward	Pull securing lever or bracket.
3	Unclip seat adapter (2)	Put sealing felt to one side and pull seat adapter forward at clips.
4	Slide seat adapter (2) out of retainer tab	Push backward in the middle.
5	Remove seat adapter (2)
6	Unscrew screw (9)	Model 203.2 Pay attention to seal beneath buckle.
			*BA91.40-P-1007-01A
7	Undo nuts (4)	Inner bearing bracket nut to floor of vehicle.
			*BA91.12-P-1003-03C
8	Release rear seat backrests (6, 7) and tilt
9	Remove loading compartment covering blind (12)	Model 203.2 Push to the left (arrow). Open rear doors.
10	Remove rear loading floor (13)	Model 203.2
11	Remove front loading floor (10)	Remove front cargo retainers (11).
12	Undo nuts (4)		*BA91.12-P-1003-03C
13	Remove 2/3 rear seat backrest (7)	Do not damage 1/3 rear seat backrest (6). 1/3 rear seat backrest must be tilted (6). Lift 2/3 rear seat backrest (7), swivel bearing bracket upward and pull 2/3 rear seat backrest (7) down from left bearing bolt (8).
14	Take out 1/3 rear backrest (6)	Lift 1/3 rear backrest (6) and pull down from right-hand bearing bolt.
15	Unscrew screws (3)	Only if outer bearing pin at wheel arch damaged.
			*BA91.12-P-1001-03C
16	Install in the reverse order

REAR SEATS

SEAT BELTS/EMERGENCY TENSIONING RETRACTORS