Install transport foil - AR97.20-P-4000V

MODEL 171 

	Installation
	Notes on transport foil	Model 129, 163, 168, 169, 170, 171, 202, 203, 208, 209, 210, 211, 215, 219, 220, 230, 240, 414
1	Remove old foils	Heat zones up only to the extent that they can still be touched; otherwise, the paint could be damaged. Removal can be facilitated by heating.
2	Clean the vehicle	Dry wet vehicle with shammy
3	Check vehicle surface	Visible edges of adhesive tape can remain (when performing reapplication). These edges are removed when the paint is prepared Minor swelling during reapplication is insignificant. The new foil can be applied to this painted surface.
4	Attach new transport foil	Do not glue foil on plastic parts and rubber seals (risk of adhesive residues). The new transport foil is applied by hand.