Remove/install interior paneling on roll bar - AR68.30-P-1380V

MODEL 171.4 

Fig 1: Identifying Interior Paneling On Roll Bar Components

Courtesy of MERCEDES-BENZ USA

MODIFICATION NOTES

24.6.04

Removal from draft stop bracket eliminated

	Remove/Install
1	Loosen paneling on right and left upper center pillar	Do not unscrew bolt from belt end fitting and do not disconnect electrical connector	AR68.30-P-1077V
2.1	Remove Parktronic warning display (PTS) in rear	Only on vehicles with code (220) Parktronic system (PTS)	AR54.65-P-0007V
3	Open lid (4)	See Operating Instructions
4	Unscrew bolts (5) and remove cover (6)	On vehicles with code (810) sound system, lay cover (6) down to side with electrical lines connected
5	Unscrew nuts (7), remove stowage compartment (8) and lay down to side	Do not disconnect electrical connectors. Installation:  Before tightening nuts (7) close cover (4) and align stowage compartment (8)
6	Unclip roll bar paneling (1) at rear from clips (9) with mounting wedge		Figure
7	Loosen roll bar paneling (1) at front from clips (10) with door paneling release lever.		*WH58.30-Z-1004-19A
8	Unclip roll bar paneling (1) upward and remove over roll bar (3)	Installation:  Replace damaged clips (9, 10). Install guides (11) behind rear paneling (arrows)
9	Install in the reverse order

Fig 2: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA

COMMERCIALLY AVAILABLE TOOLS

Number	Designation
WH58.30-Z-1004-19A	Door panel release lever