Retrofit GSM antenna - AZ82.70-P-0009-02VV
REPAIR MATERIALS
| Number | Designation |
|---|---|
| BR00.45-Z-1016-02A | Glue cartridge (150 ml) for glued windows |
- 1 Detach internal component (6) in upper area from bumper (5).
Bonded surfaces must be pretreated in accordance with adhesive manufacturer's instructions.
- 2 Attach left GSM antenna (1) as shown using listed adhesive to the bumper (5).
- 3 Route antenna line (4) into given cutout in impact absorber (8).
- 4 Attach right GSM antenna (2) as shown using listed adhesive to the bumper (5).
- 5 Clip internal component (6) completely back into bumper (5).
- 6 Wind overlength of antenna line (4) to form a loop and attach between bumper (5) and internal component (6) (see arrow).
Vehicles with code 220 Parktronic System (PTS)
- 7.1 Install antenna line (3) through grommet (7) to Parktronic wiring harness.
- 7.2 Attach antenna line (3) using tie strap to Parktronic wiring harness.
Vehicles without code 220 Parktronic System (PTS)
- 8.1 Install antenna line (3) through additionally ordered grommet (7).
- 8.2 Attach grommet (7) at a distance of 40 cm from the internal component (8) on the antenna line (3).
- 9 Route antenna line (3) through breakthrough in luggage compartment and seal with grommet (7).
- 10 Reinstall bumper.
- 11 Route antenna line (3) as shown along given lines into right of interior and fasten in place with tie straps.
- 12 Route antenna line (3) as shown along given lines and between floor covering and rocker panel in right footwell and fasten in place with tie straps.
- 13 Fasten plug (9) of antenna line (3) as shown to given wiring harness in center console using a tie strap.
- 14 Attach antenna line (3) using two strips of felt tape (see arrows) onto floor in right-hand side footwell.
- 15 Tie back overlength of antenna line (3) at suitable position in right footwell.