Standing light actuation, function - GF82.10-P-3000R

MODEL 230

Fig 1: Standing Light Actuation - Communication Diagram

Function requirements:

Circuit 30

Function sequence

If the rotary light switch (S1) is turned to the "Standing lamp" position, the driver-side SAM control unit (N10/10) sends the signal "Standing lamp On" via CAN-B to the following control units:

Passenger-side SAM control unit (N10/11)
Rear SAM control unit (N10/8)

Front standing lamp actuation

The driver-side SAM control unit (N10/10) actuates the following lamps:

Left standing and parking lamp (E1e3)
Left front side-marker lamp (E6/1)

The passenger-side SAM control unit (N10/11) actuates the following lamps:

Right standing and parking lamp (E2e3)
Right front side-marker lamp (E6/2)

Rear standing lamp actuation

The rear SAM control unit (N10/8) actuates the following lamps:

Left stop lamp, taillamp and parking lamp (E3e9)
Left side-marker lamp (E3e6)
Right stop lamp, taillamp and parking lamp (E4e9)
Right side-marker lamp (E4e6)
left license plate lamp (E19/1)
Right license plate lamp (E19/2)

If the "standing lamp On" signal with the transmitter key removed is still active, then a chime is emitted over the instrument cluster when the driver door is opened.

	Driver-side SAM control unit with fuse and relay module, location/task/design		GF54.21-P-4109R
	Front passenger-side SAM control unit with fuse and relay module, location/task/design		GF54.21-P-4111R
	Rear SAM control unit with fuse and relay module, location/task/design		GF54.21-P-4112R
	Rotary light switch module, location/task/ design		GF82.10-P-4104R