Remove/install windshield washer nozzle - AR82.35-P-6970R

MODEL 230.4 

Fig 1: Identifying Windshield Washer Nozzle Components

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Open engine hood and raise to vertical position		AR88.40-P-1000R
2.1	Remove screws (1) of cover frame (3), release catch hooks (arrows) of cable duct and remove cover frame (3)	Only when removing the right-hand windshield washer nozzle (6). Installation:  Note installation position of washer fluid hose (5) and of electrical wiring harness.
2.2	Remove screws (2) from cover (4) and remove cover (4)	Only when removing the left-hand windshield washer nozzle (6). Installation:  Note installation position of washer fluid hose (5) and of electrical wiring harness.
3	Detach washer fluid hose (5) from windshield washer nozzle (6)
4	Disconnect electrical connector (8) for washer nozzle heater from windshield washer nozzle (6)
5	Release windshield washer nozzle (6) on side at catch tabs (7) and pull out
6	Install in the reverse order
7	Check and adjust windshield washer nozzles (6)		AP82.35-P-8252BA