Emergency lamp control, function - GF82.10-P-3013R

MODEL 230 

Function 

The emergency lamp actuation is intended to prevent the complete failure of the exterior lights caused by a fault in the

• Driver-side SAM control unit (N10/10),
• SAM control unit, front-passenger side (N10/11),
• Rear SAM control unit (N10/8).

The emergency lamp is switched on within 1.5 s with circuit 15 On.

Emergency lamp actuation 

In the event of a failure of the Controller Area Network bus class B (interior) (CAN-B) or the driver-side SAM control unit (N10/10), the following lamps are activated:

• actuated by the driver-side SAM control unit (N10/10)
  • left standing and parking lamp (E1e3)
  • right low beam (E2e2)
• actuated by the passenger-side SAM control unit (N10/11)
  • right standing and parking lamp (E2e3)
  • left low beam (E1e2)
• actuated by the rear SAM control unit (N10/8)
  • left stop lamp, taillamp and parking lamp (E3e9)
  • right stop lamp, taillamp and parking lamp (E4e9)
  • left license plate lamp (E19/1)
  • right license plate lamp (E19/2)

In the event of a failure of the passenger-side SAM control unit (N10/11), the following lamps are activated:

• Right standing and parking lamp (E2e3)
• Left low beam (E1e2)

In the event of a processor failure in the rear SAM control unit (N10/8), within 3 s the following lamps are activated:

• Left stop lamp, taillamp and parking lamp (E3e9)
• Right stop lamp, taillamp and parking lamp (E4e9)
• Left license plate lamp (E19/1)
• Right license plate lamp (E19/2)

	Driver-side SAM control unit with fuse and relay module, location/task/design		GF54.21-P-4109R
	Front passenger-side SAM control unit with fuse and relay module, location/task/design		GF54.21-P-4111R
	Rear SAM control unit with fuse and relay module, location/task/design		GF54.21-P-4112R