LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2005 >> S600 >> Repair and Diagnosis >> Suspension >> Wheels & Tire System >> Wheels, Chassis Alignment Check -- Basic Knowledge -- 215 & 220 Chassis - 2 Of 2 >> Basic Knowledge >> Detection of rapid pressure loss, function - GF40.15-P-2004S

Detection of rapid pressure loss, function - GF40.15-P-2004S

MODELS 215, 220 with CODE (475) Tire pressure indicator 

Function 

Driving safety is no longer guaranteed in the event of a rapid pressure loss. The driver is advised to stop and check the condition of the tires immediately. It is the driver's responsibility to decide whether to continue the journey at low speed as far as the nearest garage or whether an on-the-spot repair is necessary (mounting the spare wheel or using TIREFIT).

If the TPM [RDK] control unit (N88) detects that a rapid pressure drop (pressure loss > 0.2 bar/minute) exists at a wheel, a "hard warning" follows (display color: "red").

This "hard warning" is displayed in the same ignition sequence. A "soft warning" follows in the next ignition sequence.

The "soft warning", if no reactivation of the system follows, is repeated for approx. 30 seconds each time the engine is started and then goes out again.

IMPORTANT On models 215, 220 as of 01.10.03 the tire pressure monitor warning lamp (A1e66) in the instrument cluster (A1) is actuated in parallel with the "hard warning". This lamp only goes out after the system is reactivated.

  Tire pressure monitor control unit, location / task / design   GF40.15-P-3001B 
  Wheel antenna, location / function   GF40.15-P-3101A 
  Wheel sensor, location / design / function   GF40.15-P-3201A 
  Tire pressure monitor activation button, location/task up to 30.09.00 GF40.15-P-3602B 
  Button for TPM system activation, location/task as of 1.10.00 up to 31.5.01 GF40.15-P-3603A 
    as of 1.6.01 GF40.15-P-3603B