Inner constant-velocity joint on rear halfshaft, extraction and pressing on - AR35.30-P-0660-02I

Shell halves (2 ea.) for pressing off and caulking the inner constant velocity joint.

Fig 1: Identifying Drift (116 589 15 15 00)

Fig 2: Identifying Clamping Jaws (220 589 02 31 00)

Measure and note distance (a) from end face of propeller shaft to constant velocity joint.
Distance (a) is usually approx. 4.0 mm to 4.3 mm.

Fig 3: Measuring Distance (A) From End Face Of Propeller Shaft To Constant Velocity Joint

Pressing off
Press off constant velocity joint using the shop-made shell halves (063a) and the drift (063).
Clean constant velocity joints.

Fig 4: Identifying Shop-Made Shell Halves And Drift

Pressing on
Fit constant velocity joint on rear axle shaft so that the collar (arrow) points towards the center of the rear axle shaft.

Fig 5: Locating Constant Velocity Joint Onto Rear Axle Shaft
Mount the clamping jaws (067) on the boot collar of the rear axle shaft (arrow).

Fig 6: Locating Rear Axle Shaft
Place rear axle shaft with clamping jaws (067) on the press.
Press on constant velocity joint all the way using drift (063).

Fig 7: Locating Clamping Jaws
Press on constant velocity joint using a suitable tube until the previously measured and noted distance (a) has been reached.
Dimension (a) is usually approx. 4.0 mm to 4.3 mm.

Fig 8: Identifying Clamping Jaws And Drift