Retrofitting pressure reservoir and pneumatic lines - AN91.25-P-0001-06N

Model 215 

1. Insert pressure reservoir (3) into the recess of the foam inserts provided and connect pneumatic line (1) to connection (2).
2. Push pneumatic line (1) through line opening (see arrow) and route along the existing pneumatic lines into the trunk.

   Attach pneumatic line (1) to the existing pneumatic lines with cable straps.

3. Remove dummy plug from T-adapter (4).
4. Fit pneumatic line (1) onto T-adapter (4).
5. Carry out operational check and inspect pneumatic lines for leaks.
   Fig 1: Identifying Pressure Reservoir And Pneumatic Lines