Replace spark plugs - AP15.10-P-1580AB

ENGINE 112.913 in MODELS 211.061 /261

ENGINE 112.949 in MODELS 211.065 /265

ENGINE 113.967 in MODELS 211.070 /270

ENGINE 113.990 in MODELS 211.076 /276

ENGINE 113.986 in MODEL 215.373

ENGINE 113.991 in MODEL 215.374

ENGINE 113.960 in MODEL 215.375, 220.875

ENGINE 112.922 in MODELS 220.063 /163

ENGINE 112.944 in MODELS 220.065 /165

ENGINE 112.972 in MODELS 220.067 /167

ENGINE 113.941 in MODELS 220.070 /170

ENGINE 113.986 in MODELS 220.073 /173

ENGINE 113.991 in MODELS 220.074 /174

ENGINE 113.960 in MODELS 220.075 /175

ENGINE 113.948 in MODELS 220.083 /183

ENGINE 113.966 in MODELS 220.084 /184

ENGINE 112.975 in MODELS 220.087 /187

ENGINE 112.973 in MODEL 230.467

ENGINE 113.992 in MODEL 230.474

ENGINE 113.963 in MODEL 230.475

ENGINE 112.917 in MODELS 211.080 /280

ENGINE 112.954 in MODELS 211.082 /282

ENGINE 113.969 in MODELS 211.083 /283

ENGINE 113.995 in MODEL 230.472

Fig 1: Identifying Spark Plugs - Models 211, 215. 220, 230

	Remove/install and replacing
	Risk of death caused by contact with parts conducting high voltages.	Do not touch parts which conduct high voltages. Persons who wear electronic implants (e.g. heart pacemakers) should never perform any work on the ignition system	AS15.10-Z-0001-01A
	Notes on avoiding damage to ignition system	Engine 104, 111, 112, 113, 119, 120, 271	AH15.10-P-0002-01D
1	Remove cover on face end of engine
2	Remove air filter housing	On model 220, 215 the air filter housing must be lifted off the support points of the cylinder head covers.
	Remove/install air filter housing	Model 211.076/276, 215.374, 220.074/174, 230.472/474	AR09.10-P-1150SVK
3	Remove cylinder 1 to 6 ignition coils (T1/1 to T1/6) or cylinder 1 to 8 ignition coils (T1/1 to T1/8)
	Remove/install ignition coils		AR15.12-P-2003A
4	Pry spark plug connector off the spark plugs using open-end wrench, double above the cylinder head cover (R4)	Double open-ended wrench	Figure
	Checking
5	Check spark plug connectors, ignition coil connectors and ignition lines for damage, deformation and crack formation	Replace, if necessary.
6	Remove spark plugs (R4)		*BA15.10-P-1001-01A
		Spark plug wrench	Fig 2
7	Install in the reverse order

SPARK PLUGS

Number	Designation		Engine 104, 110, 111, 113.940/941/942/943/ 944/948/960/961/962/ 963/964/965/966/967/ 968/969/971/980/981/ 982/984/986/992/993/ 995, 115, 117, 119, 120	Engines 112.910/911/ 912/913/914/ 915/916/917/ 920/921/922/ 923/940/941/ 942/943/944/ 945/946/947/ 949/951/953/ 954/955/960/ 961/970/972/ 973/975/976	Engine 113.987/988/ 990/991
BA15.10-P-1001-01A	Spark plugs	Nm	28	28	25

Fig 2: Identifying Spark Plug Wrench (112 589 01 09 00)

Fig 3: Identifying Open-End Wrench, Double (110 589 01 01 00)