Remove/install torsion bar on front axle - AR32.20-P-0300IW

MODELS 220.083 /084 /087 /183 /184 /187 

Fig 1: Identifying Torsion Bar On Front Axle Remove/Install Components

	Remove/Install
	Risk of death  cased by vehicle slipping or toppling off of the lifting platform.	Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
	Notes on self-locking nuts and bolts		AH00.00-N-0001-01A
1	Raise vehicle.
2	Detach lower engine compartment paneling		AR61.20-P-1105M
3	Detach link rod (23) from torsion bar (10)	Check rubber mount of link rod (23) for damage and replace link rod (23) if necessary. Installation:  Only tighten the nut (23b) when the vehicle is in the curb condition and turn the steering onto lock if necessary.
		Nut, link rod to torsion bar (10)	*BA32.20-P-1002-02H
4	Detach torsion bar (10) on the left and right of the retaining brackets (21b) from the front axle carrier and remove torsion bar (10)	Check rubber mount of torsion bar (10) for damage and wear and replace torsion bar (10) if necessary. The rubber mounts are molded onto the torsion bar (10).
		Bolts (21e) of torsion bar to front axle carrier	*BA32.20-P-1003-02H
5.1	Detach retaining brackets (21b) from torsion bar (10)	If necessary
		Bolts (21g) bottom retaining bracket to top retaining bracket	*BA32.20-P-1005-02H
6	Detach link rod (23) from steering knuckle (5)	Check boot of link rod (23) for damage and replace link rod (23) if necessary. Installation:  Counterhold joint of link rod (23) when tightening so that the boot is not twisted or damaged.
		Nut, link rod to steering knuckle	*BA32.20-P-1004-02H
7	Install in the reverse order

FRONT AXLE TORSION STRUT

Number	Designation		Model 220.083/084/087/183/184/187
BA32.20-P-1002-02H	Nut, link rod to torsion bar	Nm	95
BA32.20-P-1003-02H	Bolt, torsion bar to front end	Nm	40
BA32.20-P-1004-02H	Nut, link rod to steering knuckle	Nm	95
BA32.20-P-1005-02H	Bolt, bottom retaining bracket to top retaining bracket	Nm	95