High-pressure supply line with high-pressure expansion hose, removal and installation - AR32.50-P-1165-01A

REAR AXLE CARRIER

Number	Designation				Model 215	Model 220
BA35.10-P-1002-01A	Self-locking bolt, rear axle carrier rear rubber mount to frame floor	Nm			-	-
		with bolts- flange ø24mm	1st stage	Nm	60	60
		with bolts- flange ø24mm	2nd stage	∠°	90	90
		with bolts- flange ø 26mm	1st stage	Nm	60	60
		with bolts- flange ø 26mm	2nd stage	∠°	90	90

ACTIVE BODY CONTROL SUSPENSION

Number	Designation		Model 215	Model 220
BA32.50-P-1001-01A	Union nut, line to pressure reservoir	Nm	40	40

Open bleed screws to depressurize the ABC System.
Remove wheelhousing trim
Remove cover from rear valve module

Fig 1: Removing Cover From Rear Valve Module
Disconnect rear of exhaust system from mount and lower it slightly

Fig 2: Disconnecting Rear Of Exhaust System
Remove the self-locking bolts from the subframe bushings and carefully lower the rear axle approximately 20 cm
When lowering the rear axle watch the driveshaft, it does not need to be disconnected at the center. The rear axle must remain supported for the duration of the repairs.

Installation : Recut the threads in the sockets before installing the new bolts.

Replace self-locking bolts.

Fig 3: Locating Self-Locking Bolts
Disconnect the rapid-release retainer on the high-pressure expansion hose at the strut.
Take care to ensure that contaminants do not enter the open hose and fitting.
Disconnect the hydraulic line from the valve module.
Take care to ensure that contaminants do not enter the open fittings.
With the aid of an assistant you can now proceed to remove the high-pressure supply line with the high-pressure expansion hose.
Reverse the removal sequence to install.