Checking alignment of rear axle carrier (removed) - AR40.30-P-0410I
MODELS 220, 215
| Removing, installing | |||
| 1 | Remove, install rear axle | without Active Body Control (ABC) | AR35.10-P-0010I |
| with Active Body Control (ABC) | AR35.10-P-0010N | ||
| 2 | Remove, install rubber mount of rear axle suspension | Front rubber mount | AR35.10-P-0040-02I |
| Rear rubber mount | AR35.10-P-0040-03I | ||
| Measuring | |||
| 3 | Set up Celette straightening bench modular members | Refer to Body Plan - Celette straightening bench | |
| 4 | Insert checking fixtures (048a, 048b) into supports of Celette straightening bench | Fig 2 | |
| 5 | Place rear axle carrier complete (with axle halves) or as an individual part on the checking fixtures (048a, 048b) | *BE40.30-P-1002-07B | |
| 6 | Measure dimension "L1-L3" | Insert checking pin (L=38 mm) into supports of camber strut, tension arm and torque strut. |
*BE40.30-P-1001-07B |
| Fig 3 | |||
| Figure |
TEST VALUES FOR REAR AXLE CARRIER, TENSION ARM, CAMBER STRUT/TORQUE STRUT
| Number | Designation | Model 215 | Model 220 | ||
|---|---|---|---|---|---|
| BE40.30-P-1001-07B | Dimension | Camber strut "L1" | mm | 850 (± 2) | 850 (± 2) |
| Tension arm "L2" | mm | 914 (°2) | 914 (±2) | ||
| Torque strut "L3" | mm | 800 (±2) | 800 (±2) | ||
| BE40.30-P-1002-07B | Distance between the fixture bowl of the rear axle carrier and checking fixture | mm | ≤ 5 | ≤ 5 | |