Remove/install limp-home buffers - AR32.00-P-1000I

MODEL 220, 215 

Fig 1: Identifying Limp-Home Buffers Remove/Install Components (Shown On Model 220)

Shown on MODEL 220 

	Remove/install
	Special information on AIRmatic		AH32.22-P-1000-02I
	The limp-home buffers may only  be used for maneuvering
1	Raise corresponding side of vehicle
	Front axle
2	Mount limp-home buffer (1a) onto upper transverse control arm (6)	Limp-home buffer part number: A 220 327 12 30
3	Slowly lower vehicle and make sure that the limp-home buffer makes contact with top of wheelhouse
	Rear axle
4.1	Slide limp-home buffer (1b) in between body fold and torsion bar (77)	The body fold must lie in the groove of the limp-home buffer. For vehicles with AIRmatic only Limp-home buffer part number: A 220 328 08 39
5.1	Slowly lower vehicle and make sure that the torsion bar (77) makes contact with the limp-home buffer (1b)	Only on vehicles with AIRmatic
6	Remove in reverse order