Seat belt height adjustment mechanism (front seat) removal and installation - AR91.40-P-1100M

Models 220.0 /1 

Fig 1: Identifying Seat Belt Height Adjustment Mechanism (Front Seat) Remove/Install Components - Models 220.0 /1

	Remove/install
1	Remove front seat	up to 31.8.02.	AR91.10-P-1000M
		as of 1.9.02.	AR91.10-P-1000MB
2	Remove B-pillar paneling		AR68.30-P-4700M
3	Unclip Bowden cable (3) using Omega clip
4	Unclip Bowden cable (3) from deflection in cable duct	Lift floor lining at left front until the deflection for the Bowden cable (3) in the cable duct can be easily accessed.
5	Disassemble the Bowden cable (3) up to the belt height adjuster (1)
6	Undo nut from seat belt guide bracket (4)	Torque wrench.	Figure
		Torx bit set.	Figure
		Screw on front seat belt guide bracket	*BA91.40-P-1002-01A
7	Undo screw (2, 2 pieces) on belt height adjuster (1)	Upper screw long, lower screw short.
		Torque wrench.	Figure
		Torx bit set.	Figure
		Screw to front automatic belt height adjuster	*BA91.40-P-1009-01A
8	Install in the reverse order

SEAT BELTS/EMERGENCY TENSIONING RETRACTORS

Number	Designation		Model 220
BA91.40-P-1002-01A	Screw/nut on front seat belt guide bracket	NM	30
BA91.40-P-1009-01A	Screw to front automatic belt height adjuster	NM	24

Fig 2: Identifying Torque Wrench (001 589 66 21 00)

Fig 3: Identifying Torx Bit Set (000 589 01 10 00)