Removing, installing control module for airbag/belt tensioner - AR91.60-P-0622M

MODELS 215, 220 

Shown on model 220 

Fig 1: Identifying Control Module For Airbag/Belt Tensioner Remove/Install Components - Shown On Model 220

035	Removing, installing
	Risk of injury  when carrying out test or repair work on airbag or emergency tensioning retractor units	ETR control module with airbag and sensors for side airbags/windowbags must be from same manufacturer	AS91.00-Z-0001-01C
	Important instructions for performing repair, body work and welding on vehicles with airbags and emergency tensioning retractors		AH91.00-P-0002-01M
	The restraint systems control module (N2/7) must be replaced after three airbag deployments
1	Disconnect ground cable of battery		AR54.10-P-0003I
2	Remove center console cover (5)	Model 215	AR68.20-P-2350N
		Model 220	AR68.20-P-2350M
3	Connect coupling (1) to restraint system control module (N2/7)
4	Unscrew screws (2)	Installation:  Observe fastening of ground lead (3) at rear left screw - ground control module (W26)
5	Remove restraint systems control module (N2/7)	Installation:  the arrow (4) on the housing must point in the direction of motion.
6	Install in the reverse order
7	Store parameters on new restraint systems control module (N2/7) and program:	Star Diagnosis