Removing, installing window airbag - AR91.60-P-0693MC

MODELS 220.175 /178 with CODE (Z04) Light armoring with CODE (Z07) Top protection 

Fig 1: Identifying Window Airbag Remove/Install Components - Models 220.175 /178

	Remove/install
	Injury hazard  during test or repair work on airbag units or emergency tensioning retractor units	Store airbag unit with expulsion area on top, do not subject to temperatures above 100 °C. Interrupt power supply when working on such units.	AS91.00-Z-0001-01A
	Important instructions for performing repair, body work and welding on vehicles with airbag and emergency belt tensioner units		AH91.00-P-0002-01M
	Assessment of airbag and belt tensioner units in accident vehicles		AH91.00-P-0006-01B
	Legal provisions concerning handling and storage of airbag and emergency tensioning retractor units		AH91.00-P-0004-01A
1	Remove headliner		AR68.30-P-4300MC
2	Withdraw ignition key
3	Unscrew nuts (2) on window airbag (1)	With code (Z07) Maximum protection: Pay attention to the spacer sleeve on the upper fixing point of the gas generator of the window bag (1).
			*BA91.60-P-1005-01A
4	Disconnect coupling on the left window airbag squib (R12/16) or right window airbag squibR12/17)	Disposal:  If the window airbag (1) is replaced, the defective one should be disposed of properly: ↓
		Notes regarding the disposal of airbag and belt tensioner units	OS91.00-P-0001-01A
5	Remove window airbag (1)	Installation: The check strap (3) must be located under the sheet metal holders
6	Install in the reverse order
7	Read out fault memory
	Connect STAR DIAGNOSIS and interrogate fault memory		AD00.00-P-2000-04A
		Diagnosis system STAR DIAGNOSIS	*WH58.30-Z-1048-13A

AIRBAG CHART